HELP Needed - Activating speedcams

Hi,

[Login or Register to remove this advertisement]

The one downside I have noticed already is that if (as I normally do) program in a route and turn off the sound to avoid the (sometimes annoying) instructions, and rely on the map, it also turns off the speedcam warning bells. Using the POI's as I did before, I was able to turn off the voice instructions but still heard the warning bell for the speedcams, which was handy.

raybains Reviewed by raybains on 22nd December 2013. HELP Needed - Activating speedcams Hi, Can anyone please tell me how to activate the speedcams ? I am using the latest 9.7 Truck navcore 9.701 and the latest truck map 920_5273. on my Go930 I have used older speedcams before dating back to 2011 with navcore 9.1, and they used to show up as additional POI's. However after activating the map and the cams using fastActivate ( which indicate that they are "OK", I then re-boot the unit but cannot see the cams, either as POI's or where they should be on the map. How can I Rating: 5

Quote:

Only the registered members can see the QUOTE Contents. Please Login OR Register.

To solve this I have installed "Silent Voice".