Results 1 to 5 of 5
-
18th January 2024, 08:11 PM #1
Loading comunity voices and sounds to nav3
I have a TomTom GO 1005 Live with 2Gb internal memory and no SD Card.
I used "TTActivator-v1.20" to patch the navcore to delete the old map and to install
the new map Eastern_Europe 1120, to load the new meta, etc.
Everything is fine, the navigator works OK.
I want to load a new voice, wich is a "comunity voice". Is it possible to load it using
TTActivator? How do I do it?
Is it possible to "pack" the dataxx.chk and dataxx.vif to create a ttpkg package file
and load them using TTActivator?
Anyway, is it possible to load voices or alert sounds using TTActivator?
If I use My Drive Connect, I am afraid that the program will detect the patched navcore
and it will be rewritten.
But if there is no other way, how do I load the new voice with My Drive Connect, in the navigator?
Loading the two files dataxx.chk and dataxx.vif as they are, or putting them together in a zip archive?
Please, explain me.
Thank you.imarcel57 Reviewed by imarcel57 on . Loading comunity voices and sounds to nav3 I have a TomTom GO 1005 Live with 2Gb internal memory and no SD Card. I used "TTActivator-v1.20" to patch the navcore to delete the old map and to install the new map Eastern_Europe 1120, to load the new meta, etc. Everything is fine, the navigator works OK. I want to load a new voice, wich is a "comunity voice". Is it possible to load it using TTActivator? How do I do it? Is it possible to "pack" the dataxx.chk and dataxx.vif to create a ttpkg package file and load them using Rating: 5
-
19th January 2024, 11:22 AM #2
1. connect the device to the PC, start 1x TomTom MyDrive Connect - so that the navigation system connects to the PC.
then close TomTom MyDrive Connect completely.
2. To load a "Community Voice" use this link:
The “TTActivator” program is not required,
and the TomTom MyDrive Connect cannot delete anything because it is not switched on.Last edited by jungblume2005; 19th January 2024 at 12:50 PM.
-
20th January 2024, 08:07 PM #3
The link is not working
Thank you jungblume2005 for your answer.
Unfortunately, the link you provided does not work.
Thanks.
-
21st January 2024, 06:08 PM #4
-
The Following 2 Users Say Thank You to jungblume2005 For This Useful Post:
- [ Click To Expand ]
-
-
24th January 2024, 02:51 AM #5
Finally, I succeeded. The problem was that the device was not connected to computer.
The link opens only when the device is connected to PC. After connection, I have successfully
transferred the voices, POI-s and alert sounds. It works wery well.
Thank you again, jungblume2005.
-
The Following 2 Users Say Thank You to imarcel57 For This Useful Post:
- [ Click To Expand ]
-
jungblume2005 (24th January 2024), pe1agp (24th January 2024)
Universal Firmware Patcher for...
Hello, How can I get into the preboot mode on...