Results 11 to 17 of 17
Hybrid View
-
22nd March 2021, 03:24 AM #1
Yes, try another PC and different cables and rear ports.
If I do not make a mistake, your device would take Navcore 12.104 or 12.105, if you have updated it.
With one of these navcores he should have put Patch Truck.
followed the steps of the guide
regardssimba Reviewed by simba on . Tomtom pro 7100 stuck in recovery mode Hi, does anyone knows how to exit from recovery mode? tomtom been patched via ttactivator and now stuck in recovery mode . Every time switching on load to tomtom screen then reboots again tomtom screen and cogwheels start to spin and shows computer with red x. when connected to pc ttactivator not recognizes it. Rating: 5
-
23rd March 2021, 02:30 AM #2
Full story is it was updated to latest Navcore via Mydrive,then new map downloaded and patched with TTactivator. Next day swapped screen from another tomtom switched on and got this recovery mode on.
-
23rd March 2021, 04:58 AM #3
I do not understand exactly, it looks Navcore patch, installed Map worked. The next day "change screen" changed Hardware screen? or the next day when I turned on, recovery screen appeared?
regards
-
The Following 1 Users Say Thank You to simba For This Useful Post:
- [ Click To Expand ]
-
pe1agp (23rd March 2021)
-
26th March 2021, 12:11 AM #4
hardware screen. I think ttactivator should see tomtom in recovery mode but it doesn't appear.
-
27th March 2021, 05:06 AM #5
-
4th April 2021, 04:08 AM #6
replaced to original old lcd still goes to recovery mode. Tried with original usb cable still getting no luck to recover trough MDC. i think it all over turned into brick . unless new TTactivator will support tomtom in recovery mode.
-
26th March 2021, 05:44 PM #7
TTActivator will only see the device in normal operation, not in recovery, in fact you must use recovery mode with MDC (official TT program) and TTActivator turned off.
Import gpx
Hi, Does anyone know how to import .gpx files...