Results 11 to 20 of 42
-
5th August 2014, 02:29 AM #11
I tried to clean as good as I can but no luck..
well I just found out that when I type street number or postcode (it's the line where is numbers from 1 to 0) when I press 2 it touches 3 when I press 5 it touches 6 and so on.. so if I go a bit under its same for all other letters when I press D it touches F when I press B it touches N.. kind of strange... is it digitilazer problem ? If yes.. shall I try to calibrate or won't be necessary ?
Tried to change keyboard size, etc. but won't helped as still I cannot press '1' which is really important..
-
5th August 2014, 05:15 AM #12
It is a digitalizer problem; the offset is too important and your screens are changing without touching the display.
You still can try to calibrate, its not easy and you will need a lot of patience... but you can't break anything, just suppress cal.txt you will have created to revert back to manufacturing calibration.
-
The Following 1 Users Say Thank You to manifold For This Useful Post:
- [ Click To Expand ]
-
jarkita (5th August 2014)
-
5th August 2014, 10:21 PM #13
About cal.txt
You said that 83 932 151 844 is your current value
the first two sets ( 83 932 )is what you need to change ( sets 3 and 4 control up and down direction )
the first set controls left side of screen ( left/right direction )
second set effects is for right side ( left/right direction )
increase digits move to the right , decrease move to the left
NOTE !
it may be the the order is inverted in your info screen( depends on model )
If this is true then you must use 932 83 844 151 as a starting point instead of 83 932 151 844
-
The Following 1 Users Say Thank You to basflt For This Useful Post:
- [ Click To Expand ]
-
jarkita (5th August 2014)
-
6th August 2014, 12:56 AM #14
Here is link for full details -
Is there a chance to broke my device? as I've read on forum that some guy confused numbers and wasn't be able to press 'connect to computer' after he changed so he wasn't able to change cal.txt at all.
-
6th August 2014, 09:13 PM #15
I dont believe that , i never heard of that , although i cannot guarantee either . ( what other forum , there is only one )
I would do it .
Think it is safer then physically removing the screen .
If your device has a card-slot , you can always get the device going again .
-
The Following 1 Users Say Thank You to basflt For This Useful Post:
- [ Click To Expand ]
-
biggerdave (6th August 2014)
-
8th August 2014, 03:08 AM #16
I would first try the correct navcore first to see if you have a bad screen or its software related, like basfit says if you have a sd card slot all you need to do is prepare another card with the correct software and you will see.
-
9th August 2014, 09:32 AM #17
-
9th August 2014, 11:12 AM #18
-
10th August 2014, 08:17 PM #19
I have installed everything fresh, done reset and run flash tool, but it's still the same..
the last option now is to do calibration..
-
10th August 2014, 08:53 PM #20
I assume you installed in sd-card ?
Great , just put the cal.txt in the root of the card and experiment .
When you remove the card its gone and you boot into truck-nav from internal .
Once you get it right you can copy it to internal .
TomTom XL 2GB Device
Can you look at my profile again?😊