Results 1,061 to 1,070 of 1973
-
1st October 2020, 04:02 AM #1061
The SD card kit is just a simple method to install the Patched .gcd
Does your SD card have a new file named 154.bin on it after using the SD card kit ?
Added the patched .gcd file only ,if you want to try the method suggests, I 'm sure he will help you with installation.
Last edited by Garmin_Nuvi; 1st October 2020 at 06:29 AM.
-
1st October 2020, 02:41 PM #1062bu4xj5ppmdGuest
Ok
Yes, and I keep a copy in a safe place as it is recomended. I can confirm that the firmware is successfully installed because the version of the firmware changes (I have installed both version 6.2 and 6.3)
I have tried it using these 2 methods (with no result):
Can you explain this in greater detail?Last edited by Garmin_Nuvi; 1st October 2020 at 03:19 PM.
1st October 2020, 11:21 PM
#1063
Last edited by Garmin_Nuvi; 2nd October 2020 at 03:43 AM.
2nd October 2020, 02:57 AM
#1064
Download the attached file and the patched.rgn from Garmin_Nuvi and put the rgn and updater.exe in the same folder. put the drive track 71 in preboot mode {pres and hold the screen at the top left corner {(see the foto) the drive track 71 mast be closed not in standby)}
Last edited by Garmin_Nuvi; 2nd October 2020 at 03:29 AM.
2nd October 2020, 02:32 PM
#1065
bu4xj5ppmd
Guest
I tried updater.exe method and it finally worked!!!
For this device (Drive track 71) to enter pre boot mode the GPS must be power off. Then connect usb cable and press and hold the upper left corner of the screen.
Thank you everyone for your support
Jeep Wrangler 430n
Trying to update my maps in Wrangler on the old...