Why not try one of the already instead.
Printable View
When I click on the "North America 3.47 GB" link...
I get taken to dosy and the file shows as a GMAPPROM (8935).RAR but only 2.50 GB in size.
So, I'm on a slow satellite internet where I live (waiting on Starlink!)... and, don't want to keep hogging up my bandwidth to see if it's the file I need (which is primarily USA and Mex - which shows as a 3.7Gb file when combined in gmap).
Unless you can tell me it's correct, then... I'll do so (download and try).
Secondly, I have a JNX file error when booting the Garmin 60ST.
Is there a new file that needs to be used with the 2022.10?
N.America Map is 3.47 GB (3,730,374,656 bytes) After Compression by WinRar 2.50 GB (2,684,559,424 bytes) this is to help downloaders like yourself with limited bandwidth .
When did the "invalid JNX file" appear ? remove the map you made get the device back to the state before you tried to load these maps.
Ahhh yes... doh!
It appeared after I loaded a memory card with my 2 combined maps via gmaptool.
I'm downloading the NA map and will try it out once downloaded, and unzipped.
Thanks a bunch, fingers crossed it'll all be up and working (properly) once reloaded.
Also... about the .JNX
I bet it's one of the two birdseye files I have on the memory card! ... working it now in basecamp to see what's going on.
**UPDATE**
My birdseye subscription is no longer active. I deleted the JNX files off the memory card, and the error is gone.
However, I loaded the gmapprom downloaded as noted, and it still comes up with 'unable to authenticate...." the map. However, still allows me to use it (enable) and I believe shows on screen as "normal".
Anyway I can get that boot up map error to go away?!
Also... about the .JNX
I bet it's one of the two birdseye files I have on the memory card! ... working it now in basecamp to see what's going on.
**UPDATE**
My birdseye subscription is no longer active. I deleted the JNX files off the memory card, and the error is gone.
However, I loaded the gmapprom downloaded as noted, and it still comes up with 'unable to authenticate...." the map. However, still allows me to use it (enable) and I believe shows on screen as "normal".
Anyway I can get that boot up map error to go away?!
If you still want to use JNX files your device can be Patched
look at thread, do nothing until you confirm your HWID and post there.
Hi, Thank you for mentioning the JCV file D5294210A.jcv 353 x 390 for nuvi 6x GPS. However I can't find this file in this thread. Would you have it ?
Where can I get D5294210A.jcv? thanks.
Copied the five ASR files but when using voice command get the message "not available for your country". This on a DriveSmart 61.
Your locale is most probably set to UK, change it to USA .
https://i.imgur.com/zmkjq5A.jpg